Dmz Settings - D-Link DSR-150 User Manual

Section 5 - Connect to the Internet
Path: Network > Internet > DMZ Settings
If you set WAN2 port to DMZ, you will need to configure the port here.
To configure the DMZ Settings:
1. Click Network > Internet > DMZ Settings.
2. Complete the fields from the table below and click Save.
Field
IP Address
Subnet Mask
DHCP Mode
DHCP Server
DHCP Relay
Enable DNS Proxy
Primary DNS Server
Secondary DNS Server
WINS Server
Save
D-Link DSR-Series User Manual

DMZ Settings

Enter an IP address for the DMZ interface.
Enter the subnet mask for the DMZ interface.
Select one of the following modes:
• None - Turns off DHCP.
• DHCP Server (default) - The router will act as the DHCP server on your network.
• DHCP Relay - DHCP clients on your network will receive IP address leases from a DHCP server on a
different subnet.
Refer to "DHCP Server" on page 19 for more information.
Refer to "DHCP Relay" on page 20 for more information.
Toggle to On to manually enter DNS and/or WINS server IP address(es). If set to Off, your router's LAN
IP address will be assigned the DNS server to your clients and the router will get the DNS information
from your ISP.
If DNS Proxy is set to ON, enter the primary DNS server IP address.
If DNS Proxy is set to ON, enter the secondary DNS server IP address.
If DNS Proxy is set to ON, enter the WINS server IP address.
Click to save and activate your settings.
Description
51