Ssl Vpn; Server Policies - D-Link DSR-150 User Manual

Section 7 - VPN
SSL VPN Policies can be created on a Global, Group, or User level. User level policies take precedence over Group
level policies and Group level policies take precedence over Global policies. These policies can be applied to a
specific network resource, IP address, or IP ranges on the LAN, or to different SSL VPN services supported by the
router. The List of Available Policies can be filtered based on whether it applies to a user, group, or all users (global).
To add a SSL VPN policy, you must first assign it to a user, group, or make it global (i.e., applicable to all SSL VPN
users). If the policy is for a group, the available configured groups are shown in a drop-down menu and one
must be selected. Similarly, for a user-defined policy, a SSL VPN user must be chosen from the available list of
configured users.
The next step is to define the policy details. The policy name is a unique identifier for this rule. The policy can
be assigned to a specific Network Resource (details follow in the subsequent section), IP address, IP network,
or all devices on the LAN of the router. Based on the selection of one of these four options, the appropriate
configuration fields are required (i.e., choosing the network resources from a list of defined resources, or defining
the IP addresses). For applying the policy to addresses the port range/port number can be defined.
The final steps require the policy permission to be set to either permit or deny access to the selected addresses
or network resources. As well the policy can be specified for one or all of the supported SSL VPN services (i.e. VPN
tunnel).
Once defined, the policy goes into effect immediately. The policy name, SSL service it applies to, destination
(network resource or IP addresses), and permission (deny/permit) is outlined in a list of configured policies for
the router.
Note: You must enable Remote Management. Refer to "Remote Management" on page 172.
To create a new SSL VPN policy:
1. Make sure you have enabled remote management and have created user(s) and group(s) to assign to
this policy.
2. Click VPN > SSL VPN > SSL VPN Server Policy.
3. Click Add New SSL VPN Server Policy.
D-Link DSR-Series User Manual

SSL VPN

Server Policies

108