Display Messages - Sam4s SPS-500 Operation Manual

DISPLAY MESSAGES

Amount Required
This operation requires an amount entry.
Bad Value
The number's entered is incorrect for the task being performed.
Buffer Full
The buffer for soft check, hard check, or buffered receipt has reached capacity. For hard checks, the operator must
press the SERVICE key to print the items and clear the buffer. The operator must then pick up the previous balance
again in order to continue with finalization. In a soft check environment, this message will appear when the check has
reached capacity (maximum lines stored). The register will require the sale to be finalized with the option of printing a
bill if required.
Buffer Empty
An operation has been attempted where no information exists, for example the opening of a window look up that has
nothing to display, the attempt to transfer a check, which contains no information etc.
Busy
Destination register is busy (pre poll memory is in use). Requires a clear command from the P.C. or Register using
the s-mode menu.
Bad Command
The key sequence entered is not a valid operation.
Cash Declaration Required
Cash declaration has been programmed as compulsory, and must first be performed before reports
Cash-In-Drawer Limit Exceeded
The programmed Cash-In-Drawer limit has been exceeded.
Check# Is Assigned Automatically
The operator has attempted to open a new guest check by assigning a check number. The register has been
programmed to generate its own check numbers.
Check# Required
This register has been programmed to force check number entry to begin a transaction. An existing guest check
must be recalled, or a new one started.
Condiment Required
This PLU has been programmed to require a condiment entry.
CRC Error
An error has occurred in the block check sum while transferring data in IRC mode.
Duplicate
This check already exists. May also apply to secret code programming.
Analysis 1/Analysis 2/Analysis 3
This operation is set for compulsory entry of one of the three analysis keys.
Enter Employee Code
A registration has been attempted without entering the employee number.
- 11 - SPS-500