Carburation; Removing And Cleaning The Carburettor - GGP WBE 0701 Workshop Manual

General information
The carburettor has a float with a fixed jet and a "CHOKE" control.
See the relevant section
The carburettor is located on the left-hand side of the engine. For maintenance operations it is necessary
to dismantle the air intake filter in the sequence shown below.
Dismantle the engine from the machine following the instructions in section
Release 00 - 02/2008

8. CARBURATION

[ 15]
for advice on resolving problems due to carburation.
1
2
4

6
5
Engine WBE 0701-WBE 0704
WARNING! All operations on the tank and
supply system must be carried out in safe
conditions, so:
- do not smoke;
- always empty the tank if petrol is not strictly
necessary for the operation to be carried out;
- work in a ventilated environment away from
naked flames or unprotected sources of heat;
- collect petrol in a suitable container with a cap
using a funnel and avoid spilling it on the work
bench;
- remove all traces of spilt petrol immediately;
- check you have connected the pipes before
pouring petrol back into the tank.
8.1.

Removing and cleaning the carburettor

1 - Remove the filter element (1)
2 - Pull off the breather tube (2), unscrew the two
nuts () holding the filter carrier (4) to the engine
and remove it.
3 - Remove the clamp (5) for the petrol pipe (6)
from the side of the carburettor and use a suitable
container to collect all the petrol in the tank and
the pipe.
pag. 21
<< BACK >>
back to the index
[ 14.1].
[ 7.1].
Service manual