Adjusting Maximum Speed - GGP WBE 0701 Workshop Manual

9. GOVERNOR SYSTEM OF THE CARBURETTOR
6
8
9
8
12
11
10
Service manual
FAST
7
pag. 26
Engine WBE 0701-WBE 0704
9.2.

Adjusting maximum speed

1 - Check that the throttle cable is adjusted cor-
[ 9.1].
rectly
2 - Let the engine heat up for a few minutes then
set the throttle control to "FAST".
3 - Check the rotation speed on the speed
indicator (6).
4 - Act on the regulation screw (7) to establish the
correct value of the maximum turn system.
During the regulation, verify that the move-
ment of the mobile levels (8) don't damage the con-
tact with level air support (9) (position"CHOKE").
NOTE: The engine's maximum speed must be
between 2900 (±100) rpm; if you do not read
this value, proceed as follows.
5 - Check:
- that the spring (10) is intact and positioned at the
attachment point furthest from the fulcrum of the
control lever;
- that the wire (11) and the relative spring (12) are
intact and not deformed;
- that the moving levers (8) are not bent or defor-
med and replace the entire support if necessary
9.].
<< BACK >>
back to the index
[
Release 00 - 02/2008