Starting System; Removing The Starter Assembly; Replacing The Rope - GGP WBE 0701 Workshop Manual

General information
The starter assembly inside the cover consists of a rope wound around a pulley. The movement from the
pulley to the flywheel (and the engine shaft) is transmitted by a pair of hooks. The rope is returned and
rewound by a spiral spring.
See the relevant section
ting system.
1

4
5
Service manual

6. STARTING SYSTEM

[ 15]
for advice on resolving problems due to the malfunctioning of the star-
2

5
4
Engine WBE 0701-WBE 0704
6.1.

Removing the starter assembly

1 - To get access to the starter assembly (1), the
cover (2) must be removed by unscrewing the
three nuts ().
2 - Refit the starter assembly (1) by tightening the
cover nuts () to the torque indicated.
6.2.

Replacing the rope

1 - Remove the starter assembly
2 - Keep hold of the pulley (4) and slowly unwind
(clockwise) the entire rope (5) to gradually release
the return spring.
If the rope breaks, the spring will be already relea-
sed and you will only have to unwind the rope.
3 - Undo or cut the knot at the end of the rope
(5) and remove the section still attached to the
pulley.
pag. 18
<< BACK >>
back to the index
[ 6.1].
Release 00 - 02/2008