Dismantling And Replacing The Magneto Flywheel - GGP WBE 0701 Workshop Manual

<< BACK >>
Engine WBE 0701-WBE 0704
back to the index
1. ENGINE BLOCK - External operations
1.5. Dismantling and replacing the magneto
flywheel
24
[ 6.1].
1 - Remove the starter assembly
26
25
2 - Using an airgun, undo the nut (24) and extract
the fan (25), setting aside the starter cup (26).
3 - Undo the screw (28) and the stud (29) and re-
move the electronic coil (27).
29
28
27
4 - Using a suitable extraction tool, remove the
flywheel (0) as indicated in the diagram.
Ensure that the engine shaft key is retained.
0
5 - When fitting the flywheel check that the key (1)
is in good condition and replace it if it is deformed;
fit the starter cup (26) and the fan. Close the nut to
the indicated couple (24) and utilize a gun.
6 - Refit the coil (27), tightening the screw (28) and
the stud (29) to the torque indicated.
1
[
7 - Readjust the airgap until it is correct
10.2].
[ 6.1].
8 - Refit the starter assembly
pag. 40
Service manual Release 00 - 02/2008