Engine Wbe 0701-Wbe - GGP WBE 0701 Workshop Manual

14. ENGINE BLOCK - Overhauling internal parts
6
Service manual

Engine WBE 0701-WBE 0704

24 - Close the carter and fix the screws (6) to the
indicated couple
25 - Whenever the engine shaft is dismantled and
refitted, it is always necessary to:
- replace the sealing ring on the flywheel side
1.7];
- replace the sealing ring on the sump side
1.8].
26 - During assembly perform the operations
indicated in section
ring to replace the washer (7) between the sump
and the housing.
Tightening torques
6
Union screws under carter and sump
Counterweight governor fixing
17
screw
Fixing screws lower connecting
28
rod cap
Technical information
Oil sump capacity
Diameter aspiration cam
Diameter discharge cam
Maximum segments gap in the cylinder
Max. compression ring axial gap
Minimum gudgeon pin diameter
Max. gudgeon pin housing diameter
on piston
Max. connecting rod diameter
Diam. connecting rod's pin on engine shaft
Verify the engine shaft extremes
Special equipment
1
Piston ring removal expander
4
Piston ring compressing tool
pag. 52
<< BACK >>
back to the index
[ 14.2].
[ 14.2]
always remembe-
28,05 mm
27,72 mm
12,95 mm
13,05 mm
gudgeon pin side 13,07 mm
crank side 26,07 mm
25,92 mm
Release 00 - 02/2008
[
[
8-12 Nm
8-10 Nm
15 Nm
0,55 litri
1,0 mm
0,15 mm
0,10 mm