Replacing The Coil - GGP WBE 0701 Workshop Manual

10
Service manual
10. IGNITION
1
7
9
6
pag. 0
Engine WBE 0701-WBE 0704
7 - Perform a spark test as indicated in
10.1].
- If the spark jumps: the coil functions properly and
in the event of malfunction, verify that the cut-off
cable (1) is not earthed.
- if the spark does not jump: the coil is faulty and
[
must be replaced
8 - Refit the starter assembly

10.. Replacing the coil

1 - Remove the starter assembly
2 - Disconnect the faston of the earth cable (6).
3 - Undo the screw (9) and the stud (10) and remove
the coil (7).
4 - Mount the new coil and regulate the air gap
according to the procedure indicated in points 4
[
and 5 in section
5 - Connect the faston of the earth cable (6).
8 - Refit the starter assembly
Tightening torques
1
Spark plug tightening torque
9
Coil fixing screw
10
Coil fixing stud
Technical information
Type of spark plug RC12YC (Champion) or equivalent
Distance between electrodes
Air gap/flywheel
Special equipment

Tester for spark test
<< BACK >>
back to the index
[
10.].
[ 6.1].
[ 6.1].
10.2].
[ 6.1].
16-18 Nm
8-10 Nm
8-10 Nm
0,6-0,8 mm
0,25-0,40 mm
Release 00 - 02/2008