Etichette Di Sicurezza; Necessary Equipment; Symbols And Terms Used For Safety Purposes - GGP WBE 0701 Workshop Manual

2.4.

Etichette di sicurezza

On the canopy motor, in a immediately identifica-
tion position, are some indication or prescription
plates for the safety operator.
The plates are as follows:
1 2
• - • • • - • • • • •
4
1 - Fire hazard due to:
- Petrol or oil
Prevent by following the precautions below:
- Do not smoke or ignite a flame in the vicinity of
the petrol or oil;
- Turn engine off before adding petrol;
- Do not spill petrol on overheated or electric parts
of the engine;
- Handle or store petrol or oil in well-ventilated
areas;
- Use non-flammable oil for cleaning engine parts.
- Accumulation of flammable material
Prevent by following the precautions below:
- Remove dry leaves, chips, pieces of paper, dust or
other flammable material which has accumulated
in or is attached to the engine.
- Electrical cabling
Short circuits can cause fires. Prevent by following
the precautions below:
- Always keep the electrical connections of the
machine clean and tightly sealed;
- Tighten any loose connectors or cabling clamps.
Replace those that are damaged.
2 - Observe the instructions and warnings contained
in the present manual and on the safety plates on
the engine.
Inappropriate functioning and maintenance can
result in serious injury or even death.
 - Ventilation of closed areas:
In the event that it is necessary to start the engine
in a closed environment or if petrol or cleaning oil
is being used, open doors and windows to ensure
Service manual
2. GENERAL AND SAFETY REGULATIONS

pag. 8
Engine WBE 0701-WBE 0704
adequate ventilation and, therefore, avoid gas
poisoning.
4 - Motor label (see [
2.5.

Necessary equipment

All the operations can be carried out with the tools
normally used in a good garage.
The , symbol used for certain interventions
indicates that special tools or equipment are re-
commended.
2.6.

Symbols and terms used for safety purposes

Some paragraphs in this manual are preceded by
symbols which indicate the following:
Operations that should be carried out with ut-
most care to avoid impairing the functionality
and safety of the engine and/or lawnmower
on which it is installed.
Operations that should be carried out with
utmost care to avoid injury to operators.
"WARNING" stresses the risk of injury to oneself
and others if instructions and regulations are not
observed.
<< BACK >>
back to the index
.1])
Release 00 - 02/2008