Figure 3-2. Removing Front And Rear Supports - Eaton powerwave 9315 Installation Manual

Left Hand Door
1
9315 UPS (200–300 kVA) Installation Manual S 164201037 Rev G www.powerware.com
EATON Powerware
®
Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó
2
Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó
Ó Ó Ó
Front
Support

Figure 3-2. Removing Front and Rear Supports

5. After the foam cushions clear the floor, remove the hardware loosened in Step 3.
Pull the foam cushions from under the UPS cabinet. Discard or recycle them in a
responsible manner.
Cabinet may fall. Do not loosen hardware attaching the side or front supports to the cabinet
base. Also, do not loosen supports from each other. The cabinet must be lowered using jacking
bolts before supports can be removed.
6. Carefully lower the cabinet until the UPS cabinet base contacts the floor.
7. Remove the hardware holding the front, rear, and side supports to the cabinet
base (labeled 2" in Figure 3-2). Discard or recycle the hardware and support
brackets in a responsible manner.
8. Repeat Steps 1 through 7 for each cabinet you are preparing to install.
Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó Ó Ó Ó Ó Ó Ó
Ó Ó Ó
2
1
W A R N I N G
Installing the UPS
Side
Support
2
1
Foam
Cushion
3−3