Connecting The Cables - MUTOH ValueJet VJ-628 Startup Manual

Connecting the Cables

2 Connecting the Cables
Connecting power and Ethernet cables
1.
Before connecting the cables...
2.
Connecting the power cable
[1]
Check!
[2]
100-120V
200-240V
Note
• The voltage selector switch is set to 230 V when it is shipped.
• If the voltage selector switch does not match the voltage in your area, it causes errors.
For errors, refer to "Troubleshooting" in the operation manual.
[3]
• Close the front cover.
• Turn the media fixing knob to lock.
• Check if the waste ink clip is locked.
Make sure that the power button is turned off.
Note
• If the power switch is in a pressed-inward state, it is turned on and you must
press it again to turn it off.
Set the voltage selector switch to the voltage of the region where you
are using the product.
• For AC 100V to 120V, set the voltage selector switch to 115V.
• For AC 200V to 240V, set the voltage selector switch to 230V.
Connect the power cable to the product.
Connecting the Cables 9