Installing The Printer - MUTOH ValueJet VJ-628 Startup Manual

Concerning electric shock, short circuits and fire (continued)
CAUTION
Pay attention to the following points when
handling the power cord set.
• Do not tamper with the power cord set.
• Do not put heavy objects on the power cord set.
• Do not bend, twist or pull the power cord set by
force.
• Do not route the power cord set near heating
appliances.
• Pay attention to the following points when
handling the power plug.
Any mishandling of the power cable could cause a fire.
• Make sure that no foreign substances such as dust
are stuck to the power plug.
• Make sure that the power plug is firmly inserted to
the edge of the power socket.
Make sure that no moisture enters the printer.
It could cause shorting of the electrical circuits.

Installing the printer

WARNING
Do not install the printer on a surface:
On such surfaces the printer could topple over or fall off,
potentially causing injury.
• that is shaky, or
• that is tilted, or
• that receives vibration from other machines or
equipment nearby.
CAUTION
Do not slant the printer, prop it against a wall or turn
it upside down.
The ink inside the printer may leak.
Moreover, normal operation after shifting (to these
positions) cannot be guaranteed.
The operations of unpacking and moving this product
must be carried out by two or more persons working
together.
Never open covers attached using screws under any
circumstances.
This may cause an electric shock or a malfunction.
Before installing the dedicated stand, be sure to
turn off the printer's power and remove the
power plug from the outlet.
Otherwise there will be danger of electric shock.
When you do not use the printer for a long
period, make sure to pull out the power plug
from the power socket for safety.
Make sure to connect an earth wire to the earth
connection that meets the following standards.
• Earth terminal of power socket
• An earth wire with a copper plate which is buried at
650 mm or more in the ground.
Keep this product level when moving it.
The operation of mounting the printer onto the stand
must be carried out by two or more persons working
together.
Safety Instructions 15