Installation Location - MUTOH ValueJet VJ-628 Startup Manual

Installation location

Minimum installation space
1390 mm
Rear
Size of printer body
Front
Ensuring a suitable place for installation
Install this product in a place that:
• is level
• has no vibration
• has low humidity and little dust
• has no direct sunlight or strong lighting shining on it
• has small variation in temperature and humidity
• has no drafts (including those from heating or air conditioning equipment) blowing onto it
• has low levels of electromagnetic radiation and noise
CAUTION
Installation environment conditions
Install the product in an environment that satisfies the conditions in the table below.
Power supply
specifications
Environmental
conditions
4 Unpacking
The place should be well ventilated when you do the installation work. If it is a poorly
ventilated place, install a ventilating device.
Otherwise, the odors from the inks could impact your health.
Voltage
Frequency
Capacity
Operating environment
Ranges to ensure printing
precision
Environment for storage
Size of printer body
width×depth: 1190 mm × 438 mm
Height(with cover open)
Without stant: 573 mm
Mounted on stand: 1373 mm
AC 100 V to 120 V ±10 % or 200 V to 240 V ±10 %
50/60 Hz ±1 Hz
No less than 10 A
Temperature 20 to 32 °C, humidity 40 to 60 %,
no condensation.
Temperature 22 to 30 °C, humidity 40 to 60 %,
no condensation.
• If not charged with ink when stored: up to 6 months
Temperature -20 to +60 °C, humidity 20 to 80 %.
• If charged with ink when stored: up to 1 week*
Temperature -10 to +40 °C, humidity 20 to 80 %.
*Up to 4 days if the ambient temperature is 32 °C or higher.