Table of Contents
Advertisement
4
Insert the new hard drive in the empty slot. Slide the drive in with the locking mechanism open. Swing the lock
back down until it clicks into place.
5
Press the power button on the TeraStation.
6
When the replacement hard drive is recognized, the status LED will flash red and the message "Press FuncSW I31
New Disk x ready" will be displayed on the LCD panel.
7
Hold down the function button on the front of the TeraStation for 3 seconds until it beeps. The TeraStation will start
rebuilding the RAID array automatically. It takes about 5 minutes before the message "RAID I18 ARRAYx Rebuilding"
is displayed.
Drive Replacement (RAID 0)
Drives in a RAID 0 array do not automatically turn off in the event of a malfunction. Before replacing the failed drive,
either dismount the drive from Settings, or shut down the TeraStation.
This section describes the process of replacing a drive with
Note: If a hard drive malfunctions in RAID 0, all data on the RAID array will be lost. All of the settings for the shared
folders (such as access restrictions) are erased after replacing a drive from a RAID 0 array.
1
Open the front cover with the included key.
2
In Settings, navigate to Drives - Drives.
3
Select the hard drive with the flashing status LED and click Dismount Disk.
Note: If you reboot the TeraStation after a drive fails, the status LED will turn off. In this case, select the "Unformatted"
drive from the list and click Dismount Disk.
4
Enter the number that appears on the screen, then click OK.
5
The status LED will be glowing a steady red.
6
Unlock the failed drive by pushing the unlock button and swinging the lock mechanism out.
Note: Hard drives without red status LEDs lit are still on. Do not unplug or remove them.
7
Pull out the hard drive cartridge and remove it from the TeraStation.
8
Insert the new hard drive (sold separately) into the empty slot. Slide the drive in with the locking mechanism open.
Swing the lock back down until it clicks into place.
9
When the replacement drive is recognized, the status LED will flash red and the message "Set From Web I32 New
Diskx ready" will be displayed on the LCD panel.
Select the RAID array from Drives - RAID in Settings and click Delete RAID Array. Select the replacement hard
drive by navigating to Drives - Drives and clicking Format Disk to format the new drive. Configure RAID mode by
selecting Drives - RAID after formatting the hard drive. Enter the number that appears on the screen, then click OK.
Create a shared folder before use.
the TeraStation
on.
66
Advertisement
Table of Contents
