Buffalo terastation 3000 User Manual page 174

Hide thumbs Also See for terastation 3000:
Table of Contents

Advertisement

RAID I19
ARRAYx 0 Filling
RAID I20
DISKx Formatting
RAID I21
DISKx Checking
RAID I22
DISKx 0 Filling
SYSTEM I25
F/WUPDATING
Web Setting I26
Initializing
USB Diskx I27
Checking
USB Diskx I28
Formatting
Press FuncSW I31
New Diskx ready
Set From Web I32
New Diskx ready
Replication I33
ReplicateFailure
Virus alert I34
Virus detected
Cartridgex I35
Location error
Cartridgex I36
Decryption error
Recovery I37
SystemRecovering
Recovery I38
RecoveryFinished
Recovery I39
Change Boot
Recovery I40
DataWillDeleted
Recovery I41
PushFuncToStart
Writing 0s to RAID array X, erasing all
data.
Formatting hard drive X.
Checking hard drive X.
Erasing the data for hard drive X.
Updating the TeraStation firmware.
Note: Do not turn off the power
during the updating process.
Initializing all settings.
Checking USB hard drive X.
Formatting USB hard drive X.
Displayed when pressing the Function
button to rebuild the RAID after
replacing hard drive X.
Displayed after replacing hard drive X
when the RAID needs to be rebuilt in
Settings or formatting is necessary.
An error occurred in replication,
or synchronization between the
main TeraStation and the backup
TeraStation failed during failover
configuration.
A virus scan found a virus.
A hard drive set as a media cartridge
has been installed in the drive 1 slot.
Media cartridge cannot be decrypted.
The media cartridge may have been
encrypted by a TeraStation other than
this product.
System recovery in progress.
System recovery is complete.
System recovery from the USB
recovery device is complete.
Beginning recovery. All data on the
drive in Disk 1 will be deleted.
Pressing the Function button on the
front will start the recovery process.
-
-
-
-
-
-
-
-
Press the Function button to rebuild the RAID array.
In Settings, either rebuild the RAID array or format
the hard drive.
In Settings, navigate to Backup - Replication and
choose "Resync" to execute resynchronization. If the
error is displayed again, contact Buffalo technical
support for assistance.
Once the virus is removed from the quarantine
folder, the message is no longer displayed. If the
antivirus software is configured to delete viruses
from the quarantine folder automatically, then the
message will not be displayed.
Connect to the slot that was set as a media
cartridge.
Connect to the TeraStation that performed
encryption to decrypt.
-
-
Change the boot mode switch on the rear to HDD.
-
-
174

Advertisement

Table of Contents
loading

Table of Contents