Table of Contents
Advertisement
Recovery I42
Preparing to start the recovery
process.
Preparing
The TeraStation was started from the
Recovery I43
USB recovery device, but the system
cannot be recovered from this USB
Unsupported HW
recovery device.
Recovery from the USB recovery
Recovery I44
device was initiated, but Disk 1 was
Disk1 not found
not detected.
Recovery I45
Recovery failed.
Recovery Failed
RAID ARRAY I46
RMM+Processing
Data migration or conversion (RAID
migration) is in progress.
SYSTEM I47
Don't Power Off
This TeraStation is ready to become
FailOver I48
the failover backup for the main
PushFuncToStart
TeraStation.
FailOver I49
The main TeraStation in the failover
configuration cannot be found.
LostMainTarget
FailOver I50
Failover maintenance is in progress.
Maintenance mode
FailOver I51
Initializing the failover configuration.
Initializing
New Firmware I52
A new firmware version has been
released.
Available
BackupTask xx I54
xxth backup task has been failed.
Backup Failure
Recovery I55
Authentication during recovery of
settings failed.
RecoveryAuthFail
Surveillance I56
There are not enough surveillance
camera server licenses.
Lack of License
Surveillance I57
There is not enough space to save
additional surveillance video.
No free space
Surveillance I58
Video not recorded.
Recording Failure
-
-
Make sure that Disk 1 is present and fully inserted in
its slot.
-
Do not turn off the TeraStation power.
Hold down the Function button on the front of the
target TeraStation until it stops beeping to accept
failover backup status.
Make sure that the main TeraStation is on, working,
and connected to the network.
Do not turn off the TeraStation power.
Do not turn off the TeraStation power.
Update the firmware.
Make sure xxth backup task is configured correctly.
("xx" is backup task number.) The LinkStation or
TeraStation may be in standby mode. Start the NAS
on. If the backup task still fails, check the status of
NAS, network, and backup source or destinations.
Settings can only be restored for the TeraStation
whose settings were originally saved. To restore
settings, insert the USB memory device, move the
Boot Mode switch on the rear of the TeraStation
to the USB position, and restart the TeraStation.
Or, settings can be restored from Settings with the
TeraStation powered on.
Purchase and register an additional license.
Delete or move some of the stored video.
Check your settings. Also, use the utilities provided
with your camera to check that the camera is
operating correctly.
175
Advertisement
Table of Contents
