Power button
Powering On:
Press and hold down the small power button until the LED turns blue and the
CHS beeps twice (low-high).
Powering Off/ Disconnecting:
Press and hold down the small power button until the CHS beeps
twice (high-low).
Aim the scan beam straight
across the entire barcode.
Scanning Barcodes
After connecting the CHS to your device, open an application. Place the cursor
where you want to enter the scanned data.
1. Hold the CHS a few inches from the barcode.
2. Aim, press and hold the trigger button.
By default, the CHS will beep, vibrate, and the LED will flash green to confirm
successful scan.
BASIC FUNCTIONALITY
Not recommended
scanning techniques
5