Table of Contents
Advertisement
BASIC fUNCTIONALITY
Power button
Powering On:
Press and hold down the small
power button until the LED
turns blue and the CHS beeps
twice (low-high).
6
Powering Off/ Disconnecting:
Press and hold down the small
power button until the CHS beeps
twice (high-low).
Aim the scan beam straight
across the entire barcode.
Scanning Barcodes
After connecting the CHS to your device, open an application. Place
the cursor where you want to enter the scanned data.
1. Hold the CHS a few inches from the barcode.
2. Aim, press and hold the trigger button.
By default, the CHS will beep, vibrate, and the LED will flash green to
confirm successful scan.
USING THE SCANNER
Not recommended
scanning techniques
7
Advertisement
Table of Contents
