Basic Functionality - Socket CHS 7Mi Quick Start Manual

BASIC fuNCTIONALITy

Power button
• Powering On:
Press and hold down the small
power button until the LEd
turns blue and the CHS beeps
twice (low-high).
6
• Powering Off/ Disconnecting:
Press and hold down the small
power button until the CHS beeps
twice (high-low).
BASIC fuNCTIONALITy (CONTINuEd)
Aim the scan beam straight
across the entire barcode.
Scanning Barcodes:
After connecting the CHS to your device, open an application and put
the cursor where you want to enter data.
Hold the CHS about 4 inches (10 cm) from the barcode and press and
hold the trigger button. Keep your hand steady and make sure the
red beam covers the entire width of the barcode.
By default, the CHS will beep and vibrate, and the LED will flash
Green to confirm that data was decoded and sent to the device.
Not recommended
scanning techniques
7