Scanner Setup - Socket CHS 7Mi Quick Start Manual

SCANNER SETUP

4
Insert the Batteries
Unlock the Battery door by using
a thin coin to turn the lock under
the CHS to a horizontal position (turn 90
degrees).
Install the batteries in their correct position
as indicated by the +/- symbols.
Important: Only use NiMH Recharge-
able batteries. Do NOT use Alkaline
Batteries
Attach the Lanyard (optional)
Detach the string loop of the tether
from the lanyard. Then feed the
string loop through the slot in the Twist-lock
and then through the end of the loop. Pull
tight so the string loop is secure to the Twist-
lock, Reattach the string loop to the tether
from the Lanyard.
If desired, attach the tether to a
lanyard or belt.
Charge the CHS
The CHS must be fully charged before
first use. Please allow 5 hours uninter-
rupted charging for the initial battery
charge.
For the 7Di or 7DiRx, lift the rubber flap to
access the power connector.
• Red LED = Charging
• Green LED = Fully charged
Charging from a computer USB port is
not reliable and not recommended.
Charging Cradles & Charging QX Stand
available separately.