Jacobsen HR5111 Service And Repair Instructions page 83

(See Figure 6C-9)
10. Place the steering unit on its side. Insert the outer
sleeve of tool SJ 150-9000-11 into the sleeve bore.
11. Lubricate O-ring (22) and kin ring (21). Place them
on the guide tool as shown.
SECTION 6C. STEERING UNIT
12. Using the inner tool, push and turn the guide through
13. Pull both the inner and outer tool from the hous-
Figure 6C-9.
6C-7
the outer tool sleeve until O-ring (22) and kin ring
(21) properly seat in the housing.
ing, leaving the guide in the housing.
STEERING
6C