Jacobsen HR5111 Service And Repair Instructions page 147

INSPECTION
1. Inspect all parts for excessive wear, cracks and
broken parts.
2. Discard all O-rings, seals and backup rings.
REASSEMBLY
1. Lightly lubricate O-rings, backup rings and seals.
SECTION 8L. LIFT CYLINDER
2. Install seal kit as shown in Figure 8L-5..
3. Lubricate all parts before assembly.
4. Follow the steps as illustrated in Figure 8L-5 for
Figure 8L-5. Seal Kit Installation
8L-5
NOTE
Do not install rod O-ring at this time.
reassembly.
HYDRAULICS
8L