Dell poweredge t330 Owner's Manual page 110

NOTE: You may have to unlatch and lift the optional cable management arm if it interferes with PSU
removal. For information about the cable management arm, see the system's rack documentation.
Steps
1. Press the release latch.
2. Holding the PSU handle, pull the PSU out of the PSU bay to release the PSU from the Power
Distribution Board (PDB).
Figure 43. Removing and installing an AC PSU
1. release latch
3. PSU
5. PSU handle
Next steps
If you are not replacing the PSU in the second PSU bay immediately, install the PSU blank in the empty
PSU bay.
Related Tasks
Installing the power supply unit blank
Installing a redundant AC power supply unit
Installing a redundant AC power supply unit
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
110
Safety instructions.
2. PSU cable connector
4. connector