Internal Usb Memory Key (Optional); Replacing The Optional Internal Usb Memory Key - Dell poweredge t330 Owner's Manual

2. Follow the procedure listed in
3. Remove the cooling shroud.
Steps
1. Hold the cooling fan by the sides with the cable end facing the bottom of the chassis.
CAUTION: Do not remove or install the internal cooling fan by holding the fan blades.
2. Align the four tabs on the internal cooling fan with the four slots on the chassis wall.
3. Press and slide the internal cooling fan into the slots until the release tab locks into place.
4. Connect the internal cooling fan power cable to the FAN6 connector on the system board.
Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in
Related Tasks
Removing the cooling shroud
Installing the cooling shroud

Internal USB memory key (optional)

A USB memory key installed inside your system can be used as a boot device, security key, or mass
storage device. The USB connector must be enabled by the Internal USB Port option in the Integrated
Devices screen of System Setup.
To boot from the USB memory key, configure the USB memory key with a boot image and then specify
the USB memory key in the boot sequence in System Setup.
NOTE: To locate the internal USB connector (INT_USB) on the system board, see
jumpers and connectors.

Replacing the optional internal USB memory key

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
Steps
1. Locate the USB connector or USB memory key on the system board.
NOTE: To locate the internal USB connector on the system board, see
and connectors.
2. If installed, remove the USB memory key from the USB connector.
3. Insert the replacement USB memory key into the USB connector.
Before working inside your
After working inside your
Safety instructions.
Before working inside your
system.
system.
system.
System board jumpers
System board
89