Dell poweredge t330 Owner's Manual page 131

CAUTION: If you are using the Trusted Program Module (TPM) with an encryption key, you may
be prompted to create a recovery key during program or System Setup. Be sure to create and
safely store this recovery key. If you replace this system board, you must supply the recovery key
when you restart your system or program before you can access the encrypted data on your hard
drives.
CAUTION: Do not attempt to remove the TPM plug-in module from the system board. After the
TPM plug-in module is installed, it is cryptographically bound to that specific system board. Any
attempt to remove an installed TPM plug-in module breaks the cryptographic binding, and it
cannot be re-installed or installed on another system board.
1. Ensure that you follow the
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in
4. Remove the following components:
a. cooling shroud
b. memory modules
c. cooling fan
d. expansion cards
e. heat sink and processor
f. iDRAC port card, if installed
g. internal dual SD module, if installed
Steps
1. Disconnect all cables from the system board.
CAUTION: Take care not to damage the system identification button while removing the
system board from the chassis.
2. Remove the screws on the system board, and slide the system board toward the front of the chassis.
3. Hold the system board by the touch points and lift it out of the chassis.
CAUTION: To prevent damage to the system board, do not lift the system board by holding a
memory module, processor, or other components; hold the system board by its edges only.
Safety instructions.
Before working inside your system.
131