Troubleshooting An Optical Drive; Troubleshooting A Tape Backup Unit - Dell poweredge t330 Owner's Manual

Hide thumbs Also See for poweredge t330:
Table of Contents

Advertisement

4.
Replace the failed SD card with a new SD card.
5.
Install the system cover.
6.
Reconnect the system to its electrical outlet and turn on the system, including any attached
peripherals.
7.
Enter System Setup, and ensure that the Internal SD Card Port and Internal SD Card Redundancy
modes are set to the required modes.
Verify that the correct SD slot is set as Primary SD Card.
8.
Check if the SD card is functioning properly.
9.
If the Internal SD Card Redundancy option is set to Enabled at the time of the SD card failure, the
system prompts you to perform a rebuild.
NOTE: The rebuild is always sourced from the primary SD card to the secondary SD card.

Troubleshooting an optical drive

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
1.
Try using a different CD or DVD.
2.
If the problem is not resolved, enter System Setup and ensure that the integrated SATA controller and
the drive's SATA port are enabled.
3.
Run the appropriate diagnostic test.
4.
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
5.
If installed, remove the bezel.
6.
Remove the system cover.
7.
Ensure that the interface cable is securely connected to the optical drive and to the controller.
8.
Ensure that a power cable is properly connected to the drive.
9.
Install the system cover.
Next steps
If the problem is not resolved, see

Troubleshooting a tape backup unit

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Getting
Help.
153

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents