Installing An Optional Internal Sd Card; Removing The Optional Internal Dual Sd Module - Dell poweredge t330 Owner's Manual

NOTE: Temporarily label each SD card with its corresponding slot number before removal. Re-
install the SD card(s) into the corresponding slots.
2. Lift the SD card away from the internal dual SD module.
Next steps
1. Install an internal SD card.
2. Follow the procedure listed in
Related Tasks

Installing an optional internal SD card

Installing an optional internal SD card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
3. Ensure that the Internal SD Card Port option is set to Enabled in System Setup.
Steps
1. Locate the SD card connector on the internal dual SD module. Orient the SD card appropriately and
insert the contact-pin end of the card into the slot.
NOTE: The slot is keyed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
Next steps

Removing the optional internal dual SD module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you follow the
2. Follow the procedure listed in
3. Locate the Internal Dual SD Module (IDSDM) on the system board.
4. If installed, remove the SD card(s).
Steps
Hold the pull tab and pull the IDSDM out of the system.
98
After working inside your
Safety instructions.
Before working inside your
Safety instructions.
Before working inside your
system.
system.
system.