PLAYBACK
Note: It will take some time (within ten seconds) for the screen of the unit to enter the
normal status after you switch on the unit.
STANDBY
•
Switch on the unit. /Put the unit in standby mode.
Note: Being in the standby mode uses a minimal amount of electricity, but ensures that the
components of the unit operate at maximum efficiency from the moment you start.
SOURCE SELECT
•
Press repeatedly to select a signal source among DVD, TV, RADIO, AV IN and LINE IN.
SYSTEM
•
Press to display the PICTURE menu in which you can set the items concerning to the screen
of the unit. When the signal source is switched to the TV mode, press [SYSTEM] repeatedly
to switch to PICTURE menu, SETUP menu for TV or to exit the menu.
USB
•
Press to switch to the available extra signal source USB or SD/MS/MMC CARD, or to return
to the DVD mode. If a USB drive and a memory card are inserted in the player at the same
time, press [USB] once to select USB, press it twice to select memory card and press it for
the third time to return to the DVD mode.
OPEN/CLOSE
•
Press to open /close the disc tray.
1 2 3
4 5 6
7 8 9
0
+10
•
The digit keys can be used to input the corresponding numbers or make selection of a track
or a chapter of a disc, etc.
ENTER
•
Press to enter an item in the menu or to confirm your operation etc.
DIRECTION KEYS
•
The direction keys can be used to move the highlight or adjust the value of an item in the
menu .
SETUP
•
Press to enter/exit the setup menu.
GO TO
•
Press to enter the GO TO menu. Use the digit keys to select a title, chapter, track, track time
or disc time to go to directly. Press it again to exit.
EN - 88