Cassette Playback; Recording From Radio - Hyundai H-1427 Instruction Manual

Cassette playback

• Slide FUNCTION switch to TAPE position.
• Press STOP/EJECT button to open the
cassette compartment.
• Insert a cassette and push the cassette
door to close the cassette compartment. The
full tape reel should be on the right side.
• Press PLAY button to start playback.
• Press PAUSE button to pause playback. If
you press it again, the playback will continue.
• Press STOP/EJECT button to stop
playback, press the button again to open the
cassette door so you can take out the tape.
• When the tape plays to the end, playback
will stop automatically.
• Fast forward and rewind: You can run
forward and rewind the tape. Stop playback.
Use F.FWD button for fast forward and REW
button for fast backward playback. When you
have reached the desired tape point, press
STOP/EJECT button to stop the process.
Never use fast forward or rewind
operations during playback. This may cause
damage to the tape.
Recording

Recording from radio

• Set FUNCTION switch to RADIO position.
• Tune to the desired station by turning
TUNING control regulator.
• Insert a blank cassette into cassette
compartment.
• Press RECORD button. The recording will
start.
• For brief interruption press PAUSE button.
To resume recording press the button again.
• To stop recording press STOP/EJECT
button.
Recording from CD
• Set FUNCTION switch to CD/USB
position.
Instruction manual
• Insert your cassette tape in the cassette
compartment.
• Start the desired track playback.
• Press RECORD button. The recording will
start.
• For brief interruption press PAUSE button.
To resume recording press the button again.
• Press STOP/EJECT button when finished.
• You may want to monitor during
recording. You can adjust the sound with
VOLUME regulator. These adjustments do not
affect the content of recording.
• This deck is not suitable for recording
on CHROME (IEC II) or METAL (IEC IV) type
cassettes. For recording use NORMAL type
cassette (IEC I) on which the tabs have not
been broken.
• At the very beginning and end of the
tape, no recording will take place during the
7 seconds, when the leader tape passes the
recorder heads.
• When in process of recording or playback
the end of the tape is reached, the tape
stops automatically and the relevant button is
released.
Maintenance and care
• Check your batteries regularly, old or
discharged batteries should be replaced. If the
unit is not going to be used for some time or is
being run exclusively on the alternative power,
remove the batteries to avoid leakage and
damage.
• Electronic products of this kind should
never be subjected to moisture or extreme
temperatures.
• Do not use the unit in places where it can
be exposed to water, moisture and dust.
• If necessary, clean the unit with a piece of
cloth dampened with water only (be sure the
AC power cord is disconnected from the power
supply).
• The heads and capstan are in constant
contact with the moving tape. Use a small
5