Table of Contents
Advertisement
■ Reset Button
At the left of front panel, the reset button is designed for reboot the Managed Switch without turn off and on the power. The
following is the summary table of Reset button
Reset Button Pressed and Released
< 5 sec: System Reboot
> 5 sec: Factory Default
2.1.2 LED Indications
The front panel LEDs indicates instant status of port links, data activity and system power; helps monitor and troubleshoot when
needed.
Figure 2-1-2
shows the LED indications of these Managed Switches.
LED Indication
■ System
LED
Color
PWR
Green
SYS
Green
■ 10/100/1000Base-T interfaces
LED
Color
LNK/ACT
Green
1000
Orange
functions:
Function
Reboot the Managed Switch.
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
。
。
。
。
。
Figure 2-1-2 WGSW-28040 LED panel
Lights to indicate that the Switch has power.
Lights to indicate the system is working.
Blink to indicate the system is booting.
Lights:
To indicate the link through that port is successfully established.
Blink:
To indicate that the switch is actively sending or receiving data over that port.
Lights:
To indicate that the port is operating at 1000Mbps.
Off:
If LNK/ACT LED light-> indicate that the port is operating at 10/100Mbps
If LNK/ACT LED Off -> indicate that the port is link down
Default Username: admin
Default Password: admin
Default IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Default Gateway: 192.168.0.254
Function
Function
19
User's Manual of WGSW-28040
Advertisement
Table of Contents
