Optional Field Equipment; Required Tools; Required Adhesives; Before Starting Assembly - Hangar 9 Jackal 50 ARF Assembly Manual

Optional Field Equipment

• Self-stick weights, 6 oz (HAN3626)
• PowerPro 12V Starter (HAN161)
™
• 12V 7Ah Sealed Battery (HAN102)
• Power Panel (HAN106)
• Blue Block After Run Oil (EVOX1001)
• Cleaner and towels

Required Tools

Crimping tool Clamps
Drill Flat file
Hobby scissors Light machine oil
Low-tack tape Mixing cups
Mixing stick Felt-tipped pen
Nut driver: 5/16-inch Paper towels
Phillips screwdriver: #1, #2 Pencil
Pin vise Rotary tool
Cutoff wheel Sanding drum
Rubbing alcohol Ruler
Side cutter String
Toothpicks T-pins
Petroleum jelly Epoxy brush
Medium grit sandpaper Clear tape
Pliers
Needle nose pliers or hemostats
Ball driver or hex wrench: 1.5mm, 5/64-inch, 3/32-inch,
7/64-inch, 1/8-inch, 4mm
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm),
3/32-inch, 7/64-inch (2.5mm), 1/8-inch (3mm),
9/64-inch (3.5mm), 3/16-inch (5mm)

Required Adhesives

Medium CA (PAAPT02)
Thin CA (PAAPT08)
Threadlock (PAAPT42)
30-Minute Epoxy, 8 oz (PAAPT39)
Zap-A-Dap-A-Goo similar or flexible adhesive
6

Before Starting Assembly

Before beginning the assembly of your model, remove
each part from its bag for inspection. Closely inspect the
fuselage, wing panels, rudder and stabilizer for damage. If
you find any damaged or missing parts, contact the place of
purchase.
If you find any wrinkles in the covering, use a heat gun or
covering iron to remove them. Use caution while working
around areas where the colors overlap to prevent separating
the colors.
HAN100 – Heat Gun
HAN150 – Covering Glove
HAN101 – Sealing Iron
HAN141 – Sealing Iron Sock

Elevator and Stabilizer Assembly

Required Parts
Stabilizer hatch cover
Clevis (2) Nylon torque rod horn (2)
Silicone clevis keeper (2) Split pushrod wire
Elevator torque rod (right and left)
Stabilizer/elevator assembly (right and left)
5/16 x 10 / -inch (8mm x 263mm) anodized tube
3
8
5/16 x 5 / -inch (8mm x 146mm) anodized tube
3
4
Required Tools and Adhesives
Thin CA 30-minute epoxy
Mixing cups Mixing sticks
Rubbing alcohol Paper towels
Toothpicks Low-tack tape
T-pins Pin vise
Petroleum jelly Phillips screwdriver: #1
Medium grit sandpaper Ruler
Medium grit sandpaper Pliers
Hobby knife with #11 blade Side cutters
Clear tape Receiver
Transmitter Receiver battery
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm)

1. Locate the items for the elevator and stabilizer
assembly. You will also need to remove the stabilizer hatch
cover from the fuselage at this time.
Hangar 9 Jackal 50 ARF