Required Adhesives; Field Equipment Required; Optional Field Equipment; Before Starting Assembly - Hangar 9 Sukhoi SU-26MM SE Assembly Manual

Required Adhesives

Thin CA (PAAPT08)
Medium CA (PAAPT02)
Threadlock (PAAPT42)
5-minute Epoxy, 8 oz (PAAPT38)
30-Minute Epoxy, 8 oz (PAAPT39)
Formula 560Canopy Glue (PAAPT56)

Field Equipment Required

Ultra Fuel Pump Glow/Gas
CM-6 Spark Plug
Evolution 2-cycle oil

Optional Field Equipment

Self-stick weights, 6 oz (HAN3626)
Cleaner and towels

Before Starting Assembly

Before beginning the assembly of your model, remove
each part from its bag for inspection. Closely inspect the
fuselage, wing panels, rudder and stabilizer for damage. If
you find any damaged or missing parts, contact the place of
purchase.
If you find any wrinkles in the covering, use a heat gun or
covering iron to remove them. Use caution while working
around areas where the colors overlap to prevent separating
the colors.
HAN100 – Heat Gun
HAN150 – Covering Glove
HAN101 – Sealing Iron
HAN141 – Sealing Iron Sock
6
Required Parts
Fuselage
RF filter coil
Hook and loop tape (not included)
1/4-inch (6mm) foam rubber (not included)
24-inch servo extension (optional)
Required Tools and Adhesives
HAN155
Scissors
EVO30013309
Hex wrench: 5/64-inch
EVOX1001Q
Thin CA (for choke servo mounting holes
Hobby knife with #11 blade

1. Remove the four screws securing the canopy hatch
to the fuselage using a 5/64-inch hex wrench. Set
the hatch and screws aside until they are required for
installation.

2. Use a #1 Phillips screwdriver to remove the servo
horn from the throttle servo.

Receiver Installation

Choke servo (optional)
Receiver with accessories
Phillips screwdriver: #1

3. Use scissors to cut the tie wraps on the throttle lead
to allow room to install the RF filter coil. Install the RF
filter coil on the lead for the throttle servo to prevent
feedback from the servo getting to the receiver. The
lead will wrap through the coil three times for correct
installation. Install the RF filter coil as close to the
receiver as possible to be the most effective.

4. Plug the extensions in the receiver. Note the tags
on the extensions so they can be plugged into the
correct ports of the receiver.
hint: Plug the 6-inch (152mm) extension (included with
the AR9100 receiver) in the bind/data port. This will be
routed to the outside of the fuselage to allow binding of the
receiver and flight log data to be accessed without the need
to remove the receiver from the airframe.
Hangar 9 Sukhoi SU-26MM SE