Ap Policy - ZyXEL Communications ZyWALL 110 User Manual

8.3.2 AP Policy

Use this screen to configure the AP controller's IP address on the managed APs and determine the
action the managed APs take if the current AP controller fails. Click Configuration > Wireless >
AP Management > AP Policy to access this screen.
Figure 138 Configuration > Wireless > AP Management > AP Policy
Each field is described in the following table.
Table 76 Configuration > Wireless > AP Management > AP Policy
LABEL
Force Override AC
IP Config on AP
Override Type
Primary Controller
Secondary
Controller
Fall back to Primary
Controller when
possible
Fall Back Check
Interval
Firmware Updating
Updating Type
Apply
Reset
Chapter 8 Wireless
DESCRIPTION
Select this to have the ZyWALL/USG change the AP controller's IP address on the
managed AP(s) to match the configuration in this screen.
Select Auto to have the managed AP(s) automatically send broadcast packets to find
any other available AP controllers.
Select Manual to replace the AP controller's IP address configured on the managed
AP(s) with the one(s) you specified below.
Specify the IP address of the primary AP controller if you set Override Type to
Manual.
Specify the IP address of the secondary AP controller if you set Override Type to
Manual.
Select this option to have the managed AP(s) change back to associate with the
primary AP controller as soon as the primary AP controller is available.
Set how often the managed AP(s) check whether the primary AP controller is available.
Specify how you want the ZyWALL/USG to upgrade AP firmware.
Select CAPWAP to have the ZyWALL/USG use CAPWAP (Control and Provisioning of
Wireless Access Points protocol) to update firmware on the managed APs.
Select FTP to have the ZyWALL/USG use FTP to update firmware on the managed APs.
Click Apply to save your changes back to the ZyWALL/USG.
Click Reset to return the screen to its last-saved settings.
ZyWALL/USG Series User's Guide
168