Mounting; Rack-Mounting - ZyXEL Communications ZyWALL 110 User Manual

3.2 Mounting

Some models can be mounted in a rack, and some can be mounted on a wall.
Table 13 Mounting Method

RACK-MOUNTING

• ZyWALL 110
• ZyWALL 310
• ZyWALL 1100
• USG110
• USG210
• USG310
• USG1100
• USG1900
3.2.1 Rack-mounting
See Table 13 on page 53
steps to mount the ZyWALL/USG on an EIA standard size, 19-inch rack or in a wiring closet with
other equipment using a rack-mounting kit. Make sure the rack will safely support the combined
weight of all the equipment it contains and that the position of the ZyWALL does not make the rack
unstable or top-heavy. Take all necessary precautions to anchor the rack securely before installing
the unit.
Note: Leave 10 cm of clearance at the sides and 20 cm in the rear.
Use a #2 Phillips screwdriver to install the screws.
Note: Failure to use the proper screws may damage the unit.
Align one bracket with the holes on one side of the ZyWALL/USG and secure it with the included
1
bracket screws (smaller than the rack-mounting screws).
Attach the other bracket in a similar fashion.
2
After attaching both mounting brackets, position the ZyWALL/USG in the rack and up the bracket
3
holes with the rack holes. Secure the ZyWALL/USG to the rack with the rack-mounting screws.
Chapter 3 Hardware, Interfaces and Zones
WALL-MOUNTING
• USG40
• USG40W
• USG60
• USG60W
for the ZyWALL/USG models that can be rack mounted. Use the following
ZyWALL/USG Series User's Guide
53