ZyXEL Communications ZyWALL 110 User Manual page 565

Figure 373 Configuration > Device HA > Active-Passive Mode > Edit
Figure 374 Configuration > Device HA > Active-Passive Mode > Edit
The following table describes the labels in this screen.
Table 232 Configuration > Device HA > Active-Passive Mode > Edit
LABEL DESCRIPTION
Enable Select this to have device HA monitor the status of this interface's connection.
Monitored
Interface
Interface Name This identifies the interface.
Note: Do not connect the bridge interfaces on two ZyWALL/USGs without device HA
Either activate device HA before connecting the bridge interfaces or disable the bridge
interfaces, connect the bridge interfaces, activate device HA, and finally reactivate the
bridge interfaces.
Virtual Router IP This is the interface's (static) IP address and subnet mask in the virtual router. Whichever
(VRIP) / Subnet ZyWALL/USG is currently serving as the master uses this virtual router IP address and
Mask subnet mask. These fields are blank if the interface is a DHCP client or has no IP settings.
Manage IP Enter the interface's IP address for management access. You can use this IP address to
access the ZyWALL/USG whether it is the master or a backup. This management IP
address should be in the same subnet as the interface IP address.
Manage IP Enter the subnet mask of the interface's management IP address.
Subnet Mask
OK Click OK to save your changes back to the ZyWALL/USG.
Cancel Click Cancel to exit this screen without saving your changes.
Chapter 34 Device HA
activated on both. Doing so could cause a broadcast storm.
ZyWALL/USG Series User's Guide
565