Changing Cycles And Options; Status Lights - Whirlpool WFC7500VW0 User Manual

• Follow the manufacturer's instructions to
determine the amount of detergent to use.
NOTE: Overfilling could cause an oversudsing
condition.
Chlorine bleach compartment
(Letter C in Dispenser Illustration)
Add NO MORE THAN 1/2 cup (120 mL) liquid
chlorine bleach to this compartment. The bleach
will be automatically diluted and dispensed
at the best time during the first rinse after the
wash cycle. This compartment cannot dilute
powdered bleach.
• Use only liquid chlorine bleach in this dis-
penser. Do not use this dispenser to add
powdered chlorine or any form of colorsafe
bleach to your load.
• Always measure liquid chlorine bleach. Use
a measuring cup with a pour spout; do not
guess. Follow the manufacturer's directions
for proper use.
• Do not fill beyond the "MAX" level.
NOTE: Overfilling could cause garment dam-
age.
Fabric softener compartment
(Letter D in Dispenser Illustration)
Add 1/2 cup (120 mL) liquid fabric softener
to this compartment. Fabric softener will be
automatically dispensed in the final rinse or in
the EXTRA RINSE, if selected.
• Do not fill beyond the "MAX" level.
RESTARTING
To restart the washer at any time, select CAN-
CEL/DRAIN.

CHANGING CYCLES AND OPTIONS

Not all Options are available with all Cycles.
Cycles and Options can be changed anytime
before START is selected.
To stop a cycle and select a new cycle
1. Press and hold CANCEL/DRAIN for 3
seconds.
2. Select desired cycle..
3. Select the desired OPTIONS.
4. Select and hold START (for approximately
3 seconds) to restart the washer at the
beginning of the new cycle.
To cancel a cycle and to drain the washer
manually
1. Press and hold CANCEL/DRAIN for 3
seconds.
2. The pump will turn on to drain out the water
and the door will unlock.
NOTE: t will take approximately 1 minute
for the door to unlock.
3. The washer cycle stops, the door unlocks
and clothes can be removed.
4. To power down the washer manually after
the wash cycle is complete, switch knob
to Off position.
NOTE: If the water level is too high, the
washer will drain automatically before the
door unlocks.
.

STATUS LIGHTS

These lights show which portion of the cycle
the washer is operating.
3-5