REMOVING THE MOTOR CONTROL UNIT
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1.
Unplug washer or disconnect power.
2.
Turn off the water supply to the washer.
3.
Remove the front access panel (see page
4-9 for the procedure).
Motor Control Unit
4.
Unclip wire harness from motor controller
holders.
5.
Remove the wire tie from the cover.
Harness Holder
Wire Tie
Harness Holder
6.
Remove two screws holding motor con-
trol to unit.
Motor Control Unit
Continued on the next page.
4-17
Screws