Whirlpool WFC7500VW0 User Manual page 60

10 Remove the two 13mm bolts from the top
rear weight, then remove the weight from
the washer.
REASSEMBLY NOTE: When removing top
rear weight leave ridgid vent attached to it.
13mm Bolts
11. Remove the bellows from the tub (see
pages 4-12 through 4-13 for the proce-
dure).
12. Using a shallow pan to catch the water,
unscrew the filter from the drain pump,
and drain the water from the pump.
13. Loosen the clamp and remove the pump-
to-tub hose from the drain pump.
REASSEMBLY NOTE: When you reconnect
the hose, align the tab with the arrow on the
drain pump.
Drain Pump Filter
Pump-To-Tub Hose
Tab
14. Remove the rear panel (see page 4-20
for the procedure).
15. Remove the basket drive pulley from the
basket shaft (see page 4-22 for the pro-
cedure).
16. Remove ground wire that is connected to
the bearing hub, and pull the wire out of
the tub holes.
Ground Wire Screw
17. Disconnect the pressure hose from the
pressure switch.
Pressure Hose
4-24
Bearing Hub
Pressure Switch