Whirlpool WFC7500VW0 User Manual page 75

NO WATER DETECTED ENTERING MACHINE OR PRESSURE SWITCH TRIP NOT DETECTED
F01
Water level is not reached within a variable time (EEPROM parameter) in whirlpool factory test
Possible Causes/Procedure
If there is no water in the unit:
Make sure that both valves at the water source(s) are turned on all the way.
Check for plugged or kinked inlet hoses or plugged screens in the inlet valves .
Verify inlet valve operation.
If there is water in the unit:
Verify drain pump operation.
Verify that the pressure switch hose is in good condition and properly connected to tub and pressure switch.
Remove hose from pressure switch. Dislodge any debris build up in the hose inside the outer tub.
1. Verify there is not a siphon problem.
2. Unplug washer or disconnect power.
3. Verify wire harness connections to inlet valves, pressure swi t ch, drain pump and Central Control Unit (CCU).
4. Check all hoses for possible leaks.
5. Plug in washer or reconnect power
6. Verify pressure switch operation.
7. Verify CCU operation by running a Quick Diagnostic Test or any cycle
OVERFLOW CONDITION
F02
Overflow level has been reached, and last for more than 2 seconds. In an overflow condition, the door remains locked and
the drain pump runs constantly, and after 10 minutes, door will be unlocked in order to cut off the valves power. Then if
overflow s till happens, start pump again. Turn off hot and cold water faucets and unplug the unit before servicing.
Possible Causes/Procedure
1. Check the drain hose and make sure it is not plugged or kinked .
2. Unplug washer or disconnect power, if water still flows into the washer, replace the water valve.
3. Check wire harness connections to the drain pump, pressure switch, water inlet value, and Central Control Unit (CCU).
4. Check/clean drain pump filter of foreign objects.
5. Check for drain pump failure.
6. Check the inlet valve for proper shut off.
7. Check the pressure switch for proper operation.
8. Remove hose from pressure switch. Dislodge any debris build up in the hose inside the outer tub. Debris in side the
hose will not allow the switch to sense a pressure change.
LONG DRAIN
F03
If the drain time exceeds 4 minutes the water valves turn off.Only in factory test.
NOTES: Rotate knob to clear the display.
Possible Causes/Procedure
1. Turn washer ON to verify pump operates.
2. Check the drain hose and make sure it is not plugged or kinked.
3. Unplug washer or disconnect power.
4. Check the electrical connections at the pump and make sure the pump is running.
5. Check the drain pump filter for foreign objects.
6. Plug in washer or reconnect power.
7. If the above does not correct the problem, go to step 8.
8. Unplug washer or disconnect power.
9. Replace the pump.
6-3