SunStar SPS/D-B1201 SERIES User Manual page 15

F. Assemble the hinge and the hinge rubber on the bed,
and insert the adjusting bolt into the hinge hole at ①.
Then fasten it on the table (below) as in the figure.
To prevent safety accident, the machine should be carried by at least two people.
Danger
G. Open the hinge area on the table (above) and erect
the sewing machine. Insert the fixing bolt into the
hinge hole at ① and fix it on the table.
The machine has not been completely assembled. When erecting the machine, make sure to prevent
the occurrence of a safety accident.
Danger
H. Assemble the safety switch bracket① on the bed as
in the figure. Move the safety switch bracket up or
down to adjust the safety switch support rubber② to
tightly press the safety switch③, and then fasten the
tightening screw④.
Fixing bolt
Hinge rubber
①
Hinge
①
Fixing bolt
Table (above)
①
②
[Figure 13]
①
[Figure 14]
④
③
Table (below)
[Figure 15]
15