Setting steps
1. Loosen the screw in the opening (4).
2. Loosen the counternut (8).
3. Rotate the frame (2) such that the connecting rods (1) are in a line.
4. Turn the stop screw (9) such that the ball-ended pin (7) is in contact with
5. Tighten the counternut (8).
6. Turn the torsion spring (5) with the pin (3) 15° to 20° in the direction of
11.2 Adjusting the drive dog for the presser foot bar
Proper setting
When the stitch length is set to 0 and both feet (8) and (9) are at the same
height:
The drive dog (15) is attached to the presser foot bar (10) in such a
Cover
• Arm cover ( p. 11).
• Head cover ( p. 12).
Fig. 41: Adjusting the presser foot bar drive dog I
(1) - Screw
(2) - Pin
(3) - Screws
(4) - Shaft
(5) - Gully
(6) - Assembly
(7) - Plate
(8) - Presser foot
60
it and the connecting rods (1) remain in a line.
the arrow and tighten the screw in the opening (4).
position that the needle shaft inserted into the opening (11) touches
the presser foot bar (10).
①
②
③
④
⑤
⑥
⑦
Adjusting the sewing foot feed
(9) - Sewing foot
(10) - Presser foot bar
(11) - Opening for the needle shaft
(12) - Slide nut
(13) - Lever
(14) - Drive dog screw
(15) - Drive dog
Service Instructions 967 - 02.0 - 12/2015