DURKOPP ADLER 967 Instruction Manual page 34

Hide thumbs Also See for 967:

Table of Contents

 No play on the stitch regulator gear. The plates for the gear are paral-

Cover

• Tilt the machine head ( p. 10)

Setting steps

1. Switch off the machine at the main switch.

 The machine switches over to the upper stitch length adjusting wheel.

Fig. 21: Setting the upper stitch length adjusting wheel I

(1) - Upper stitch length adjusting wheel

(2) - Screw

(3) - Lower stitch length adjusting wheel

(4) - Adjusting mark

2. Hold the upper stitch length adjusting wheel (1) using a wrench (7).

3. Loosen the screw (2).

4. Remove the upper stitch length adjusting wheel (1) from the shaft (5).

5. Carefully turn the shaft (5) clockwise using a 10 mm wrench.

lel, the frame cannot be moved.

①

②

③

NOTICE

Machine damage possible if the shaft is turned too strongly.

If you turn the shaft too far, then parts on the stitch regulator gear

could bend or get stuck.

Turn the shaft carefully and stop as soon as you can feel slight

resistance.

Setting the stitch length adjusting wheels

(5) - Shaft

(6) - Scale

(7) - Wrench

Service Instructions 967 - 02.0 - 12/2015

⑦

⑥

⑤

④

Table of Contents