DURKOPP ADLER 967 Instruction Manual page 43

Setting the feed dog
Fig. 28: Moving the feed dog carrier
④
(1) - Adjusting ring
(2) - Screws
(3) - Stroke shaft
(4) - Clamp
Setting steps
1. Position the upper stitch length adjusting wheel to 0.
2. Loosen screw (6) and adjusting ring (7).
3. Loosen screws (2) and adjusting ring (1).
4. Move the feed dog carrier across the line of the sewing direction such
5. Slide adjusting ring (1) and clamp (4) towards each other as far as they
6. Tighten the setscrew of the adjusting ring (1) as well as the screws (2).
7. Slide adjusting ring (7) and clamp (8) towards each other as far as they
8. Tighten the setscrew of the adjusting ring (7) as well as the screw (6).
Service Instructions 967 - 02.0 - 12/2015
③ ②
⑤
⑥
that the feed dog is exactly in the center of the throat plate cut-out.
will go.
When doing this, make sure that the stroke shaft (3) is firmly held by
the clamp (4) and the adjusting ring (1).
will go.
When doing this, make sure that the sliding shaft (5) is firmly held by
the clamp (8) and the adjusting ring (7).
①
⑧
⑦
(5) - Sliding shaft
(6) - Screw
(7) - Adjusting ring
(8) - Clamp
41