Setting the feed dog
8
The position and the movement of the feed dog and needle bar have to be
coordinated such that the needle pierces exactly in the center of the nee-
dle hole of the feed dog.
Sequence
First check the following setting:
• Needle bar linkage ( p. 47)
8.1 Setting the feed dog position
Proper setting
When the stitch length is set to 0 and the needle is at the bottom dead center:
The center of the feed dog opening (2) lines up with the axle of the
Cover
• Tilt the machine head ( p. 10).
Service Instructions 967 - 02.0 - 12/2015
Setting the feed dog
WARNING
Risk of injury!
Crushing injuries from moving parts.
Switch off the machine before setting the feed dog
position.
needle.
39