DURKOPP ADLER 967 Instruction Manual page 79

Adjusting the thread cutter
Fig. 53: Basic setting of the thread cutter
①
②
③
④
⑤
⑥
⑦
(1) - Roller
(2) - Gage
(3) - Upper lever
(4) - Control cam
(5) - Base plate
(6) - Stop lever
(7) - Screws
Setting steps
1. Loosen the screws (7) of the stop lever (6) and the screws (9) of the
2. Secure the screws (11) for the lower lever (12) to the flat on the lower
3. Put the handwheel into the 80° position ( p. 20).
4. Lightly tighten the screws (7) of the stop lever (6) such that the stop
5. Insert a 0.1 mm feeler gage (2) between the control cam (4) and roller (1).
6. Press the upper lever (3) down and, at the same time, turn the stop lever
7. Tighten both screws of the stop lever (7).
8. Check the distance between the roller (1) and control cam (4), and adjust
Service Instructions 967 - 02.0 - 12/2015
lever (10).
shaft (13) and tighten both screws.
lever (7) can be turned on the lower shaft (13) with a slight frictional
torque.
(6) until it contacts the base plate (5).
it if necessary.
(8) - Piston
(9) - Screws
(10) - Lever
(11) - Screws
(12) - Lower lever
(13) - Lower shaft
⑬
⑫
⑪
⑩
⑨
⑧
77