Setting steps
1. Screw in the setscrew (4) so that a stroke is available.
2. Position the upper stitch length adjusting wheel to 0.
3. Loosen the setscrews (2).
4. Turn the stroke eccentric (1) such that the feeding foot touches down
5. Tighten the setscrews (2).
6. Loosen the setscrew (4) far enough so that the plates (3) are, once
64
on the feed dog when the handwheel is in the 95° position and the tip
of the needle is at the height of the upper edge of the feeding foot.
When doing so, do not move the stroke eccentric (1) laterally on the
axle.
again, in a line.
Adjusting the sewing foot feed
Service Instructions 967 - 02.0 - 12/2015