DURKOPP ADLER 967 Instruction Manual page 36

Fig. 23: Setting the lower stitch length adjusting wheel I
(1) - Key for the stitch length
Setting steps
1. Position the upper stitch length adjusting wheel (3) > 3.
2. Switch machine to short stitch length.
 The key for the stitch length (1) does not light up.
Fig. 24: Setting the lower stitch length adjusting wheel II
(1) - Upper stitch length adjusting wheel
(2) - Screw
(3) - Lower stitch length adjusting wheel
(4) - Adjusting mark
3. Hold the lower stitch length adjusting wheel (3) using the wrench (7).
4. Loosen the screw (2).
5. Remove the lower stitch length adjusting wheel (3) from the shaft (5).
34
①
on the machine arm
If the key lights up, press key (1) again.
①
②
③
NOTICE
Machine damage possible if the shaft is turned too strongly.
If you turn the shaft too far, then parts on the stitch regulator gear
could bend or get stuck.
Turn the shaft carefully and stop as soon as you can feel slight
resistance.
Setting the stitch length adjusting wheels
(2) - Lower stitch length adjusting wheel
(3) - Upper stitch length adjusting wheel
(5) - Shaft
(6) - Scale
(7) - Wrench
Service Instructions 967 - 02.0 - 12/2015
③
②
⑦
⑥
⑤
④