Positioning The Arm Shaft - DURKOPP ADLER 967 Instruction Manual

Positioning the arm shaft

4
Proper setting
The 3 setscrews (1) are seated flush on the flat. The arm shaft crank is
flush with the machine casting.
Cover
• Upper left cover, ( p. 11).
Fig. 14: Setting the arm shaft crank
(1) - Setscrews
Setting steps
1. Loosen all setscrews (1) on the arm shaft crank.
2. Turn the arm shaft crank such that the setscrews (1) are seated flush
3. Push the arm shaft to the right as far as it will go and flush with the
4. Tighten all setscrews (1) on the arm shaft crank.
Service Instructions 967 - 02.0 - 12/2015
Positioning the arm shaft
WARNING
Risk of injury!
Crushing injuries from moving parts.
Switch the machine off before you check and set
the position of the arm shaft crank.
on the flat of the arm shaft.
machine casting.
①
21