Setting The Feed Dog; Setting The Feed Dog Position - DURKOPP ADLER M-TYPE 667 Service Instructions Manual

Setting the feed dog

8
The position and the movement of the feed dog and needle bar have to be
coordinated such that the needle pierces exactly in the center of the nee-
dle hole of the feed dog.
Order
First, check the following setting:
• Needle bar linkage ( p. 43)

8.1 Setting the feed dog position

Proper setting
The feed dog is exactly in the center of the throat plate cut-out, both side-
ways and in the sewing direction.
If the stitch length is 0, the needle pierces exactly in the center of the nee-
dle hole.
Various settings can be made depending on how far the position of the
feed dog differs from the correct setting:
• For minimal deviations, it suffices to move the feed dog on the carrier
• If this is not sufficient, move the entire feed dog carrier on the sliding
Service Instructions 667 - 00.0 - 04/2016
Setting the feed dog
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before you set the feed dog
position.
( p. 36).
shaft ( p. 36).
35